[. . . ] ENGLISH
INSTRUCTION MANUAL
Cordless Percussion-Driver Drill
BHP442 BHP452
008357
WARNING: For your personal safety, READ and UNDERSTAND before using. 1
ENGLISH
SPECIFICATIONS
Model Concrete Steel Capacities Wood Wood screw Machine screw No load speed (min )
-1
BHP442 13 mm 13 mm 38 mm 6 mm x 75 mm M6 0 - 1, 400 0 - 400 0 - 21, 000 0 - 6, 000 215 mm 1. 7 kg (BL1430) D. C. 14. 4 V
BHP452
10 mm x 89 mm M6 0 - 1, 500 0 - 400 0 - 22, 500 0 - 6, 000 215 mm 1. 8 kg (BL1830) D. C. 18 V
High (2) Low (1) High (2) Low (1)
Blows per minute Overall length Net weight Rated voltage
· Due to our continuing programme of research and development, the specifications herein are subject to change without notice. [. . . ] Before using battery cartridge, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery. If operating time has become excessively shorter, stop operating immediately. It may result in a risk of overheating, possible burns and even an explosion. If electrolyte gets into your eyes, rinse them out with clear water and seek medical attention right away. Do not short the battery cartridge: (1) Do not touch the terminals with any
2. 3.
4.
SPECIFIC SAFETY RULES
DO NOT let comfort or familiarity with product (gained from repeated use) replace strict adherence 4
5.
6.
7.
8.
conductive material. Avoid storing battery cartridge in a container with other metal objects such as nails, coins, etc. A battery short can cause a large current flow, overheating, possible burns and even a breakdown. Do not store the tool and battery cartridge in locations where the temperature may reach or exceed 50 C (122 F). Do not incinerate the battery cartridge even if it is severely damaged or is completely worn out. To insert the battery cartridge, align the tongue on the battery cartridge with the groove in the housing and slip it into place. Always insert it all the way until it locks in place with a little click. If you can see the red part on the upper side of the button, it is not locked completely. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. If the cartridge does not slide in easily, it is not being inserted correctly.
Switch action
1. Switch trigger
SAVE THESE INSTRUCTIONS.
Tips for maintaining maximum battery life
1. Always stop tool operation and charge the battery cartridge when you notice less tool power. Charge the battery cartridge with room temperature at 10 C - 40 C (50 F - 104 F). When not operating the tool, always set the reversing switch lever to the neutral position.
This tool employs an action mode changing ring. Select one of the three modes suitable for your work needs by using this ring. For rotation only, turn the ring so that the arrow on the tool body points toward the mark on the ring. For rotation with hammering, turn the ring so that the arrow points toward the mark on the ring. [. . . ] Place the point of the driver bit in the screw head and apply pressure to the tool. CAUTION: Make sure that the driver bit is inserted straight in the screw head, or the screw and/or bit may be damaged.
A stuck bit can be removed simply by setting the reversing switch to reverse rotation in order to back out. · Always secure small workpieces in a vise or similar hold-down device. · If the tool is operated continuously until the battery cartridge has discharged, allow the tool to rest for 15 minutes before proceeding with a fresh battery. [. . . ]